Desktop 4500 Setup
Proceed through the following directions to set up your system. You may need a 5/32”
Allen wrench and a T10 Torx screwdriver to align the printer.
Install Printer
The following procedure explains how to install the Liberty printer on the Desktop
4500. The Desktop 4500 includes two alignment blocks on the printer adjustment
plate to hold and position the printer.
1 – Printer Adjustment Plate 2 – Alignment Blocks
1. Open the printer top cover and place the Liberty printer on the printer adjustment
plate so the alignment slots slide over the alignment blocks. The picture below
shows the alignment blocks coming up through the alignment slots located at the
bottom of the printer. Make sure the printer is pressed down so the blocks
protrude through the hole openings.
1 – Printer Top Cover 2 – Alignment Blocks 3 – Liberty Printer
2. Close the printer top cover.
3. Go to the “Connect Cables” section on page 11.
Installation 10