Back to Contents Page
Removing and Installing Parts
Dell™ XPS™ 710 H2C Edition Service Manual
Before You Begin
Removing the Computer Cover
Memory
Cards
Drives
Hard Drive
Drive Panel
Floppy Drive
Media Card Reader
CD/DVD Drive
Liquid Cooling Assembly
Processor
Battery
Removing the Computer Stand
Replacing the Computer Cover
Before You Begin
This chapter provides procedures for removing and installing the components in your computer. Unless otherwise noted, each procedure assumes that a component can be replaced by performing the removal procedure in reverse order.
Recommended Tools
The procedures in this document may require one or more of the following tools:
Small
Phillips screwdriver
Flash BIOS update (see the Dell support website at support.dell.com)
Preparing to Work Inside Your Computer
Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To reduce the risk of fire, electric shock, or injury, do not overload an electrical outlet, power strip, or convenience receptacle. The total ampere rating of all products plugged into an electrical outlet, power strip, or other receptacle should not exceed 80 percent of the branch circuit rating.
CAUTION: Your computer is heavy and can be difficult to maneuver. Seek assistance before attempting to lift, move, or tilt the computer and always lift correctly to avoid injury; avoid bending over while lifting.
