Dell 710 H2C, DCDO service manual Removing the Drive Panel, Replacing the Drive Panel

1		power cable	2	data cable
9.	Replace the computer cover (see Replacing the Computer Cover).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

10. Connect the computer and devices to electrical outlets, and turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

Drive Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

Removing the Drive Panel

1.Follow the procedures in Before You Begin.

2.Remove the computer cover (see Removing the Computer Cover).

3.Grasp the drive release latch and slide it towards the base of the computer until the drive panel snaps open.

1 drive release latch 2 drive panel 3 drive panel tabs

4.Pivot the drive panel outward and lift it from its side hinges.

5.Set the drive panel aside in a secure location.

Replacing the Drive Panel

1. Follow the procedures in Before You Begin.