Dell DCDO, 710 H2C service manual Removing the Processor, Installing the Processor

12. Connect your computer and devices to electrical outlets, and turn them on.

Processor

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE: Do not perform the following steps unless you are familiar with hardware removal and replacement. Performing these steps incorrectly could damage your system board. For technical service, see Dell Hardware Warranty Support Policy (U.S. Only).

Removing the Processor

1.Follow the procedures in Before You Begin.

2.Remove the computer cover (see Removing the Computer Cover).

3.Disconnect the power cables from the POWER1 and POWER2 connectors (see System Board Components) on the system board.

4.Remove the liquid cooling assembly (see Removing the Liquid Cooling Assembly).

5.Push down and out on the socket release lever.

6.Lift the socket release lever and open the processor cover.

1	processor cover	2	processor	3	socket
4	socket release lever

7. Remove the processor from the socket.

Leave the release lever extended in the release position so that the socket is ready for the processor to be replaced.

Installing the Processor