Removing the Consumer IR Board
1.Follow the instructions in “Before You Begin” on page 6.
2.Remove the battery pack (see “Removing the Battery Pack” on page 11).
3.Remove the compartment door (see “Removing the Compartment Door” on page 14).
4.Remove the hard drive (see “Removing the Hard Drive” on page 17).
5.Remove the memory module(s) (see “Removing the Memory Module(s)” on page 21).
6.Remove the center control cover (see “Removing the Center Control Cover” on page 30).
7.Remove the keyboard (see “Removing the Keyboard” on page 34).
8.Remove the palm rest (see “Removing the Palm Rest” on page 38).
9.Remove the display assembly (see “Removing the Display Assembly” on page 73).
10.Remove the magnesium cover (see “Removing the Magnesium Cover” on page 83).
11.Disconnect the consumer IR board cable from the system board connector.
12.Remove the two screws that secure the consumer IR board to the computer base.
13.Lift the consumer IR board off the computer base.
CHAPTER 20: CONSUMER IR BOARD
1
2
3
1 | screws (2) | 3 consumer IR board connector |
2 | consumer IR board |
|
092/092
