The parameters are:
– For a Loopback interface, enter the keyword loopback then a number between zero (0) and
16383.
– For a 10-Gigabit Ethernet interface, enter the keyword tengigabitEthernet then the slot/port
information.
– For a VLAN, enter the keyword vlan then a number from 1 to 4094.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• Match destination routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip address prefix-list-name
• Match next-hop routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip next-hop {access-list-name | prefix-list prefix-list-name}
• Match source routes specified in a prefix list (IPv4).
CONFIG-ROUTE-MAP mode
match ip route-source {access-list-name | prefix-list prefix-list-name}
• Match routes with a specific value.
CONFIG-ROUTE-MAP mode
match metric metric-value
• Match routes specified as internal or external to OSPF, ISIS level-1, ISIS level-2, or locally generated.
CONFIG-ROUTE-MAP mode
match route-type {external [type-1 | type-2] | internal | level-1 | level-2 |
local }
• Match routes with a specific tag.
CONFIG-ROUTE-MAP mode
match tag tag-value
To create route map instances, use these commands. There is no limit to the number of match
commands per route map, but the convention is to keep the number of match filters in a route map low.
Set commands do not require a corresponding match command.
Configuring Set Conditions
To configure a set condition, use the following commands.
��� Generate a tag to be added to redistributed routes.
CONFIG-ROUTE-MAP mode
set automatic-tag
• Specify an OSPF area or ISIS level for redistributed routes.
CONFIG-ROUTE-MAP mode
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
Access Control Lists (ACLs) 133