Figure 125. BPDU Filtering Enabled Globally
Selecting STP Root
The STP determines the root bridge, but you can assign one bridge a lower priority to increase the
likelihood that it becomes the root bridge. You can also specify that a bridge is the root or the secondary
root.
To change the bridge priority or specify that a bridge is the root or secondary root, use the following
command.
• Assign a number as the bridge priority or designate it as the root or secondary root.
PROTOCOL SPANNING TREE mode
bridge-priority {priority-value | primary | secondary}
–priority-value: the range is from 0 to 65535. The lower the number assigned, the more likely
this bridge becomes the root bridge.
The primary option specifies a bridge priority of 8192.
The secondary option specifies a bridge priority of 16384.
The default is 32768.
Example of Viewing STP Root Information
To view only the root information, use the show spanning-tree root command from EXEC privilege
mode.
Dell#show spanning-tree 0 root
Root ID Priority 32768, Address 0001.e80d.2462
We are the root of the spanning tree
Spanning Tree Protocol (STP) 921