• Set the delay time for VRRP initialization on an individual interface.
INTERFACE mode
vrrp delay minimum seconds
This time is the gap between an interface coming up and being operational, and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
• Set the delay time for VRRP initialization on all the interfaces in the system configured for VRRP.
INTERFACE mode
vrrp delay reload seconds
This time is the gap between system boot up completion and VRRP enabling.
The seconds range is from 0 to 900.
The default is 0.
Sample Configurations
Before you set up VRRP, review the following sample configurations.
VRRP for an IPv4 Configuration
The following configuration shows how to enable IPv4 VRRP. This example does not contain
comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You
can copy and paste from the example to your CLI. To support your own IP addresses, interfaces, names,
and so on, be sure that you make the necessary changes. The VRRP topology was created using the CLI
configuration shown in the following example.
1020 Virtual Router Redundancy Protocol (VRRP)