on vty0 (10.11.9.209)
%RPM0-P:CP %SEC-3-AUTHENTICATION_ENABLE_SUCCESS: Enable password
authentication success on vty0 ( 10.11.9.209 )
Monitoring TACACS+
To view information on TACACS+ transactions, use the following command.
• View TACACS+ transactions to troubleshoot problems.
EXEC Privilege mode
debug tacacs+
TACACS+ Remote Authentication and Authorization
The Dell Networking OS takes the access class from the TACACS+ server. Access class is the class of
service that restricts Telnet access and packet sizes.
If you have configured remote authorization, the system ignores the access class you have configured for
the VTY line. The system instead gets this access class information from the TACACS+ server. The Dell
Networking OS must know the username and password of the incoming user before it can fetch the
access class from the server. A user, therefore, at least sees the login prompt. If the access class denies
the connection, the system closes the Telnet session immediately.
The following example demonstrates how to configure the access-class from a TACACS+ server. This
configuration ignores the configured access-class on the VTY line. If you have configured a deny10 ACL
on the TACACS+ server, Dell downloads it and applies it. If the user is found to be coming from the
10.0.0.0 subnet, Dell also immediately closes the Telnet connection. Note, that no matter where the user
is coming from, they see the login prompt.
When configuring a TACACS+ server host, you can set different communication parameters, such as the
key password.
Example of Specifying a TACACS+ Server Host
Dell#
Dell(conf)#
Dell(conf)#ip access-list standard deny10
Dell(conf-std-nacl)#permit 10.0.0.0/8
Dell(conf-std-nacl)#deny any
Dell(conf)#
Dell(conf)#aaa authentication login tacacsmethod tacacs+
Dell(conf)#aaa authentication exec tacacsauthorization tacacs+
Dell(conf)#tacacs-server host 25.1.1.2 key Force10
Dell(conf)#
Dell(conf)#line vty 0 9
Dell(config-line-vty)#login authentication tacacsmethod
Dell(config-line-vty)#authorization exec tacauthor
Dell(config-line-vty)#
Dell(config-line-vty)#access-class deny10
Dell(config-line-vty)#end
798 Security