Dell(conf-if-te-2/2)#
In the following example, the dead interval is set at 4x the hello interval (shown in bold).
Dell (conf-if-te-2/2)#ip ospf dead-interval 20
Dell (conf-if-te-2/2)#do show ip os int tengig 1/3
TenGigabitEthernet 2/2 is up, line protocol is up
Internet Address 20.0.0.1/24, Area 0
Process ID 10, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State DR, Priority 1
Designated Router (ID) 1.1.1.2, Interface address 30.0.0.1
Backup Designated Router (ID) 1.1.1.1, Interface address 30.0.0.2
Timer intervals configured, Hello 20, Dead 80, Wait 20, Retransmit 5
Hello due in 00:00:04
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with neighbor 1.1.1.1 (Backup Designated Router)
Dell (conf-if-gi-2/2)#
Configuration Information
The interfaces must be in Layer-3 mode (assigned an IP address) and enabled so that they can send and
receive traffic. The OSPF process must know about these interfaces.
To make the OSPF process aware of these interfaces, they must be assigned to OSPF areas.
You must configure OSPF GLOBALLY on the system in CONFIGURATION mode.
OSPF features and functions are assigned to each router using the CONFIG-INTERFACE commands for
each interface.
NOTE: By default, OSPF is disabled.
Configuration Task List for OSPFv2 (OSPF for IPv4)Open shortest path first version 2 (OSPF for IPv4) is supported on the MXL switch.
The following configuration tasks include two mandatory tasks and several optional tasks:
•Enabling OSPFv2 (mandatory)
•Enabling Multi-Process OSPF (OSPFv2 IPv4 Only)
•Assigning an OSPFv2 Area (mandatory)
•Enable OSPFv2 on Interfaces
•Configuring Stub Areas
•Configuring LSA Throttling Timers
•Enabling Passive Interfaces
•Enabling Fast-Convergence
•Changing OSPFv2 Parameters on Interfaces
•Enabling OSPFv2 Authentication
•Redistributing Routes
624 Open Shortest Path First (OSPFv2 and OSPFv3)