snmp-server community
2. From the Dell Networking system, identify the interface index of the port for which you want to
change the admin status.
EXEC Privilege mode
show interface
Or, from the management system, use the snmpwwalk command to identify the interface index.
3. Enter the snmpset command to change the admin status using either the object descriptor or the
OID.
snmpset with descriptor: snmpset -v version -c community agent-ip
ifAdminStatus.ifindex i {1 | 2}
snmpset with OID: snmpset -v version -c community agent-ip .
1.3.6.1.2.1.2.2.1.7.ifindex i {1 | 2}
Choose integer 1 to change the admin status to Up, or 2 to change the admin status to Down.
Fetch Dynamic MAC Entries using SNMP
Dell Networking supports the RFC 1493 dot1d table for the default VLAN and the dot1q table for all other
VLANs.
NOTE: The 802.1q Q-BRIDGE MIB defines VLANs regarding 802.1d, as 802.1d itself does not define
them. As a switchport must belong a VLAN (the default VLAN or a configured VLAN), all MAC
address learned on a switchport are associated with a VLAN. For this reason, the Q-Bridge MIB is
used for MAC address query. Moreover, specific to MAC address query, the MAC address indexes
dot1dTpFdbTable only for a single forwarding database, while dot1qTpFdbTable has two indices —
VLAN ID and MAC address — to allow for multiple forwarding databases and considering that the
same MAC address is learned on multiple VLANs. The VLAN ID is added as the first index so that
MAC addresses are read by the VLAN, sorted lexicographically. The MAC address is part of the OID
instance, so in this case, lexicographic order is according to the most significant octet.
Table 64. MIB Objects for Fetching Dynamic MAC Entries in the Forwarding Database
MIB Object OID MIB Description
dot1dTpFdbTable .1.3.6.1.2.1.17.4.3 Q-BRIDGE MIB List the learned unicast
MAC addresses on the
default VLAN.
dot1qTpFdbTable .1.3.6.1.2.1.17.7.1.2. 2 Q-BRIDGE MIB List the learned unicast
MAC addresses on non-
default VLANs.
dot3aCurAggFdb Table .1.3.6.1.4.1.6027.3.2. 1.1.5 F10-LINK-
AGGREGATION -MIB
List the learned MAC
addresses of aggregated
links (LAG).
In the following example, R1 has one dynamic MAC address, learned off of port GigabitEthernet 1/21,
which a member of the default VLAN, VLAN 1. The SNMP walk returns the values for dot1dTpFdbAddress,
dot1dTpFdbPort, and dot1dTpFdbStatus.
Simple Network Management Protocol (SNMP) 875