3.Perform the following steps to remove the LED board:
a.Disconnect the LED board connector cable by lifting the release tab upwards. [1,2]
b.Remove the screws that secure the LED board. [3]
c.Lift and remove the LED board from the computer. [4]
Figure 13.
Installing the LED Board
1.Align the LED board to its location on the chassis.
2.Install the screws that secure the LED board to the computer.
3.Connect the LED board connector cable to the system board.
4.Install:
a.ExpressCard
b.bottom cover
c.hard drive
d.battery
5.Follow the procedures in After Working Inside Your Computer.
Removing the Fingerprint reader
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove:
a.battery
b.hard drive
c.bottom cover
d.ExpressCard
27
