Installing The LED Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals.
2.Disconnect the power cable from the power source.
3.Remove the bezel, if applicable.
4.Align the LED module with the standoffs on the chassis.
5.Install the screws to secure the LED module to the chassis.
6.Paste the LED label on the LED Module.
Control-Panel Board
Removing The Control-Panel Board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.If installed, remove the front bezel.
2.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
3.Open the system.
4.Remove the 3.5 inch
5.Disconnect the
CAUTION: Do not pull on the cable to unseat the connector. Doing so can damage the cable.
a)Press the metal tabs on the ends of the cable connector.
b)Gently work the connector out of the socket.
6.Remove all the cables connecting the
7.Remove the screw(s) securing the
41
