Dell R710 owner manual VFlash Media Optional

3If installed, remove all expansion cards from expansion-card riser 1. See "Removing an Expansion Card."

4Remove the VFlash media card (if installed) from the iDRAC6 Enterprise card. See "VFlash Media (Optional)."

5If present, disconnect the Ethernet cable from the iDRAC6 Enterprise card.

6Remove the iDRAC6 Enterprise card:

a Pull back slightly on the two tabs at the front edge of the card and gently lift the front edge of the card off of the retention standoffs.

b As the card releases from the standoffs, the connector under the card disengages from the system board connector.

c Slide the card away from the back of the system until the RJ-45 connector is clear of the back panel, then lift the card out of the system.

7Install the plastic filler plug for the vacated RJ-45 Ethernet port in the system back panel.

8Reinstall the expansion card(s) in expansion-card riser 1. See "Installing an Expansion Card."

9Close the system. See "Closing the System."

10Reconnect the system and peripherals to their power sources, and turn them on.

VFlash Media (Optional)

The optional VFlash media is a Secure Digital (SD) card that can be used with the optional iDRAC6 Enterprise card. See "Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise Card (Optional)."

1Locate the VFlash media slot on the back of the system and insert the contact-pin end of the SD card (with the label side facing up) into the slot. See "Back Panel Features and Indicators" for the slot location.

NOTE: The slot is keyed to ensure correct insertion of the card.

2Press inward on the card to lock it into the slot.

To remove the card, push inward on the card to release it, and pull the card from the card slot.

96

Installing System Components