7If not already done, connect the power and interface cables from the optical drive to the system board connectors.
a Connect the power cable to the DVD/TBU_PWR connector on the front of the system board below the fan bracket. See Figure
b Route the interface cable along the inside right wall of the chassis. See "Cable Routing" and Figure
c Connect the cable to the SATA_A connector on the system board. See Figure
8Close the system. See "Closing the System."
9Replace the bezel. See "Installing the Front Bezel."
10Reconnect your system and peripherals to their electrical outlets, and turn on the system.
Figure 3-15. Removing and Installing the Optical Drive
2
1
3
4
1 | optical drive | 2 | |
3 | power cable | 4 |