Delta 36-978 instruction manual To the Arbor Pulley

3.Slide the belt and pulley guard bracket (I) Fig. 36, between the motor plate (J) and motor mounting plate (K), as shown.

4.Place a ¼" External Tooth Lockwasher onto a ¼-20

x1 ½" Hex Head Screw. Insert the screw (L) Fig. 36, through the hole in the belt and pulley guard bracket

(I)as shown in Fig. 36.

5.Position belt and pulley guard bracket (I) Fig. 37, so the motor pulley (K) is centered and through the hole in the belt and pulley guard bracket (I), as shown in Fig. 37. Tighten the four hex nuts (C) Fig. 31 that fasten the motor to the motor mounting plate.

6.Using a straight edge, align the motor pulley with the arbor pulley in the saw cabinet. If necessary, adjust the motor pulley (K) Fig. 37, in or out on the motor shaft.

7.Lift up on the motor and assemble the drive belt

(L)Fig. 38, to the arbor pulley and motor pulley (K) Fig 38. The weight of the motor will provide the correct belt tension.

8. IMMEDIATELY AFTER ASSEMBLING THE BELT, RAISE THE SAW BLADE

TO ITS MAXIMUM HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES. USING A STRAIGHT EDGE (M) FIG. 39, CHECK TO SEE IF THE MOTOR END (N) FIG. 39,

IS BELOW THE TOP OF THE TABLE SURFACE (O). IF THE MOTOR END IS ABOVE THE TOP OF THE TABLE SURFACE, LOOSEN THE FOUR HEX NUTS (F) FIG. 31, RE-POSITION MOTOR AND THEN RETIGHTEN THE NUTS. THEN, RE-ALIGN THE MOTOR PULLEY (K) FIG. 38

TO THE ARBOR PULLEY.

L

J	I
	K

Fig. 36

I P Q

L

K

Fig. 37

L

K

Fig. 38

M

O

N

Fig. 39

16