Delta 36-978 instruction manual G H C

7.Assemble the blade guard and splitter assembly

(G) Fig. 47, between the large washer (C) and the splitter bracket and tighten screw (H) with wrench supplied. Slide splitter as far down as it will go.

8. Fasten the rear of the blade guard and splitter bracket

assembly (G) Fig. 48, to the rear splitter mounting

bracket. Align the hole (J) in the blade guard and

splitter bracket with the hole in the rear splitter

mounting bracket. Insert a 5/16-18 x 5/8" Carriage

Head Screw through the hole and place a 5/16" Flat

Washer on the screw and fasten with a 5/16-18 Hex

Nut, and tighten securely.

G

H

C

Fig. 47

L G

IMPORTANT: The splitter (G) Fig. 49, has a notch (L) cut in the top edge as shown. This feature will enable the blade guard to stay in the raised position to make blade changing easier. Raise the front of blade guard (M), until the rear edge of the blade guard slips into notch (L) of splitter (G); the blade guard will stay in this position. This feature only works when the table insert is removed.

9.With the blade guard (L) Fig. 50, in the raised position, attach the saw blade (K) on the arbor with the two arbor wrenches provided (No. 7 and 8, Fig. 1). For more instructions on changing blades, see “CHANGING THE SAW BLADE” section in this manual.

Fig. 48

M

L

Fig. 49

J

G

L

K

Fig. 50

19