Delta DVPEN01-SL

Ethernet Communication Module DVPEN01-SL

DVP-PLC Operation Manual

5. Enter the password to temporarily unlock the protection and modify the parameters. If you close the

setup page, the locking will automatically be recovered.

6. To clear the password, simply leave the password columns blank. Click on “OK” to clear the

password.

Contents

Main Ethernet Communication Module Operation Manual Page Ethernet Communication Module DVPEN01-SL Warning Table of Contents Page 1 Introduction 1.1 Functions 1.2 Specifications 2 Product Profile & Outline 2.1 Dimension 90 [3.543] 60 [2.362] 3 Installation & Wiring 3.1 Installation 4 Control Register (CR) 4.1 Control Registers in DVPEN01-SL Page 4.2 Explanations on CR Page Page Page Page 4.3 Numbering of Left-Side Modules 5 Setting up Software 5.1 Setting up Communication & Searching for Modules Page Page Page Page Page 5.2 Basic Settings 5.3 Network Settings Page Page 5.4 Setting up E-Mails 5.5 Data Exchange 5.6 RTU 5.7 IP Filter 5.8 Static ARP Table 5.9 Setting up Password 5.10 Returning to Default Setting 6 Application Examples 6.1 Setting up IP and Communicating through WPLSoft Page Page 6.2 Connecting the PC with DVPEN01-SL through LAN Page Page Page 6.3 Setting up Password and Clearing Password Page 6.4 When the Password is Lost (Returning to Default Setting by RS-232) 6.5 IP Filter Protection Page 6.6 Setting up Static ARP Table Page 6.7 Application of E-Mail If the rising-edge of X0 is triggered, X0 will go from Off to On. Write 1 into CR#3 of If the falling-edge of X0 is triggered, X0 will go from On to Off. Write 1 into CR#4 of If the rising-edge of Y0 is triggered, Y0 will go from Off to On. Write 1 into CR#5 of If the falling-edge of Y0 is triggered, Y0 will go from On to Off. Write 1 into CR#6 of 6.8 Application of Data Exchange (1) Page Page 6.9 Application of Data Exchange (2) 6.10 Application of Data Exchange (3) 6.11 Application of Data Exchange (4) Write the IP address of PLC_A into CR#25 and CR#26. The first two IP codes (192.168 = 6.12 Application of Data Exchange (5) Write 0 into CR#28, and PLC_B will use CR#25 ~ CR#26 as the IP address of the destination Write the IP address of PLC_A into CR#25 and CR#26. The first two IP codes (192.168 = 6.13 Application of Modbus TCP Master Set CR#111 as 1 to enable the 8-bit mode. The Modbus instruction is stored in the low byte of 6.14 RTU Mapping