Ethernet Communication Module DVPEN01-SL

6.10Application of Data Exchange (3)

Available in firmware V2.0 and later versions

Application

Network requirement

Enable a timer (X20) and write the timer values into D0 ~ D99. Control the program (X21) and write the present values in D0 ~ D99 of PLC_A into D0 ~ D99 of PLC_B, and write the values in D0 ~ D99 of PLC-B into D200 ~ D299 of PLC_A. Control the program (X21) to stop the execution.

(1)Adopting static IP.

(2)IP of PLC_A: 192.168.1.99

(3)IP of PLC_B: 192.168.1.97”

(4)Update from PLC_A to PLC_B and PLC_B to PLC_A.

1.See 6.1 for how to set up the communication.

2.Open the setup page of PLC_A and switch to “Data Exchange” page.

3.Check “Enable Data Exchange” box. Select “Program Control” for Execute Mode. Enter IP address of PLC_B “192.168.1.97”, D200ÅD0 Quantity: 100 and D0ÆD0 Quantity: 100 in No. 1 Data Exchange Host IP column. Click “OK” to complete the setting.

DVP-PLC Operation Manual

49

Page 51
Image 51
Delta operation manual Ethernet Communication Module DVPEN01-SL