Delta Electronics RTU-EN01 operation manual Smart PLC Timer

Modbus TCP Remote I/O Communication Module RTU-EN01

7.16 Smart PLC: Timer

Application	Setting up Smart PLC functions by DCISoft. After RY0 is On for 1 second, it will turn Off for 500
	ms. This will repeat in cycle.

(1)Set up the timer: Timer 0 1s, Timer 1 500ms.

Steps

(2)Set up IF-THEN: When the timing reaches the target, RY0 will be On or Off.

1.Open the setup page and switch to “Smart PLC” page. Further switch to the “Timer” page.

2.Check to “Enable” Timer 0 and Timer 1 and set Timer 0 to “1s” and Timer 1 to “500ms”. Click “Apply” to write the settings into RTU-EN01.

DVP-PLC Operation Manual 43