System Setup

Setting the Test Tone

•Use this setting to adjust to that the playback level between the different channel is equal.

•From the listening position, listen to the test tones produced from the speakers to adjust the level.

•The level can also be adjusted directly from the remote control unit.

1

• Press the CURSOR F button to switch the test
tone mode.

 

• Press the ENTER or CURSOR H button to

 

switch to the digital input (COAXIAL) setting.

 

 

 

 

 

 

*TEST TONE Yes<

 

 

 

 

 

 

 

 

 

2 Press the CURSOR F or G button to select the test tone mode, then press the CURSOR H button to start test tone.

T . TONE Auto >

Auto Manual

Auto:

Adjust the level while listening to the test tones produced automatically from the different speakers.

Manual:

Select the speaker from which you want to produce the test tone to adjust the level.

4 Press the CURSOR F or G button to set the center channel level, then press the CURSOR H button to switch to the front R channel level (manual mode).

5 Press the CURSOR F or G button to set the front R channel level, then press the CURSOR H button to switch to the surround R channel level (manual mode).

6 Press the CURSOR F or G button to set the surround R channel level, then press the CURSOR H button to switch to the surround L channel level (manual mode).

7 Press the CURSOR F or G button to set the surround L channel level, then press the CURSOR H button to switch to the subwoofer channel level (manual mode).

8 Press the CURSOR F or G button to set the subwoofer channel level, then press the ENTER button to finish the test tone.

9 Press the ENTER or CURSOR H button to switch the Digital In Assignment (COAXIAL) setting.

ENGLISH

System Setup

2Adjusting the test tone

•Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup or from the remote control unit, as described below.

•Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the STANDARD (DOLBY/DTS SURROUND) modes. The adjusted levels for the different modes are automatically stored in the memory.

1 Press the STANDARD button to select theSTANDARD (DOLBY/DTS SURROUND) modes.2 Press the TEST TONE button.

• Test tones are output from the different speakers.

3 Press the CURSOR F or G button to adjust so that the volume of the test tones is the same for all the speakers.

4 After completing the adjustment, press the TEST TONE button again.

3 Press the CURSOR F or G button to set the front L channel level, then press the CURSOR H button to switch to the center channel level (manual mode).

AUTO - FL

 

FL VOL

 

0dB

 

 

 

 

 

 

 

 

 

-12dB

 

0dB

 

+12dB

 

 

 

•When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer’s own volume control.

•When you adjust the channel levels while in the system setup channel level mode, the channel level adjustments made will affect all surround modes. Consider this mode a master channel level adjustment mode.

•After you have completed the system setup channel level adjustments, you can then activate the individual surround modes and adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode, your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each surround

mode ( page 27).

14

ENGLISH