Denon AVR-1306 Basic Operation, MODE, NOTE:, VOLUME, MUTING, STATUS, DIMMER, ANALOG, ANALOG, MUTING, VOLUME, SPEAKER, EXT. IN, ENGLISH, Playback, SURROUND, INPUT MODE

ENGLISH

Basic Operation

Basic Operation

Playback using the external input (EXT. IN) terminals

Playback

INPUT MODE ANALOG MASTER VOLUME

SPEAKER EXT. INPHONES SURROUND MODE SELECT INPUT SELECTOR

SURROUND

MODE

INPUT SELECTOR

	VOLUME
	MUTING
STATUS
VIDEO SELECT	SPEAKER
	EXT. IN
INPUT MODE
	DIMMER
	ANALOG

Playing the input source

1 Select the input source to be played.

Example: CD

(Main unit) (Remote control unit)

2 Select the play (surround) mode.

Example: STEREO

	SELECT
(Main unit)	(Remote control unit)

To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the SURROUND MODE button and then operate the selector.

3 Start playback on the selected component.

For operating instructions, refer to the component’s manual.

4 Adjust the volume.

	The volume level is
	displayed on the
	master volume level
(Main unit)	(Remote control unit) display.

The volume can be adjusted within the range of –70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is

set as described ( page 27), if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to “18 dB — (Maximum value of channel level)”.)

The signals being input to the external decoder input terminals are played without passing through the surround circuitry.

Press the EXT. IN button to select the external input.•Cancelling the external input mode:Press the INPUT MODE or ANALOG button to switch to thedesired input mode ( page 18, 19).

•The external input mode can be set for any input source. To watch video while listening to sound, select the input source to which the video signal is connected, then set this mode.

•If the subwoofer output level is too high, set the “SW ATT.” surround parameter to “ON”.

NOTE:

•When the input mode is set to the external input (EXT. IN), the play mode (DIRECT, VIRTUAL SURROUND, STEREO, STANDARD (DOLBY/DTS SURROUND), 5CH STEREO or DSP SIMULATION) cannot be selected.

•In play modes other than the external input mode, the signals connected to the EXT. IN terminals cannot be reproduced. In addition, signals cannot be output from channels not connected to the input terminals.

Turning the sound off temporarily (MUTING)Use this to turn off the audio output temporarily.Press the MUTING button.•Canceling the MUTING mode:q Press the MUTING button again.

w Press the VOLUME button on the remote control unit, or adjust the volume up or down via the front panel MASTER VOLUME knob.

17

ENGLISH