Denon AVR-1910 Completed, Once Connections are

ENGLISH

Getting	Antenna terminals
Started	Direction of broadcasting station
Connections	FM antenna
	75 Ω/ohms	AM loop
	Coaxial cable	antenna
Settings
	FM indoor antenna	(supplied)
	(supplied)
Playback
-Multi	AM outdoor antenna Ground
Zone	nAM loop antenna assembly
Remote
	Remove the vinyl tie and take	out the
Control	1connection line.
	2Bend in the reverse direction.
Information
	3-1stable surface.
Troubleshooting	With the antenna on top of any
	Mount
Specifications	3-2wall.With the antenna attached to a
	Installation hole Mount on wall, etc.
	nConnection of AM antennas
	1Push the lever.

2Insert the conductor.

Connecting Devices not Equipped with HDMI terminals

3Return the lever.

NOTE

•Do not connect two FM antennas simultaneously.

•Even if an external AM antenna is used, do not disconnect the AM loop antenna.

•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

Connecting the Power Cord

Wait until all connections have been completed before connecting the power cord.

Power cord

To household power outlet (AC 120 V, 60 Hz)

Connection to the AC outlets

•These outlets supply power to external au- dio equipment.

•Audio equipment with a total power con-

sumption of 120 W (1 A) can be connect- ed.

•The power supply turns on and off together

with the on the main unit. When set to “ON”, power is supplied from the outlet. When set to “STANDBY”, no power is sup- plied.

NOTE

When “HDMI Control” (vpage 28) is set to “ON”, power is supplied constantly to the AC outlet (UNSWITCHED).

NOTE

•Insert the AC plugs securely. Incomplete connections could cause noise.

•Only use the AC outlets to plug in audio equipment. Do not use them as power supplies for hairdryers or anything other than audio equipment.

Once Connections areCompleted

Turning the Power On

1	Press	.
	The power indicator lights red and the
2	power is set to the standby mode.
	Press	.	Front
	The power indicator flashes green and the
	power turns on.
bAlso press		when in	standby

mode, the power turns on.

When has been pressed, the input source set with the

is set. If a has been pressed, the input source stored in the memory for the quick select function is set (vpage 50 “Saving frequently used settings (Quick Select Function)”).

This operation can also be performed by pressing a	on
the main unit.

Turning the Power Off

1	Press .	Front
2	The power is set to the standby mode.
	Press	.

The power indicator turns off, and so does the power.

NOTE

•Power continues to be supplied to some of the circuitry even when

the power is in the standby mode. When leaving home for long

periods of time or when traveling, either press to turn off the power, or unplug the power cord from the power outlet.

•When the ZONE2 power is switched on, and you want to switch off

the MAIN ZONE power, press .

17