ENGLISH

Getting

 

Cautions on Handling

 

• Before turning the power switch on

Started

 

 

Check once again that all connections are correct and that there are

 

no problems with the connection cables.

 

Power is supplied to some of the circuitry even when the unit is

Connections

 

set to the standby mode. When traveling or leaving home for long

 

 

 

 

periods of time, be sure to unplug the power cord from the power

 

 

outlet.

Settings

• About condensation

 

If there is a major difference in temperature between the inside of

 

the operating parts inside the unit, causing the unit not to operate

 

 

the unit and the surroundings, condensation (dew) may form on

Playback

 

properly.

 

If this happens, let the unit sit for an hour or two with the power

 

 

 

 

turned off and wait until there is little difference in temperature

 

 

before using the unit.

Multi

• Cautions on using mobile phones

 

Using a mobile phone near this unit may result in noise. If so, move

-

 

the mobile phone away from this unit when it is in use.

Zone

 

• Moving the unit

 

Remote

 

Turn off the power and unplug the power cord from the power

 

Next, disconnect the connection cables to other system units before

 

 

outlet.

Control

 

moving the unit.

Note that the illustrations in these instructions may differ from the

 

Information

 

actual unit for explanation purposes.

 

 

Troubleshooting

 

 

Specifications

 

 

 

 

 

Cautions on Installation

Note:

For proper heat dispersal, do not install this unit in a confined space, such as a bookcase or similar enclosure.

b Note

b

b

b

Wall

About the Remote Control Unit

In addition to the AVR-1910, the included remote control unit (RC- 1117) can also be used to operate the equipment listed below.

q DENON system components

w Non-DENON system components

• By setting the preset memory (vpage 52)

Inserting the Batteries

q Lift the clasp and remove the

w Load the two batteries properly

rear cover.

as indicated by the marks in

 

the battery compartment.

 

R6/AA

e Put the rear cover back on.

NOTE

Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit.

The supplied batteries are only for verifying operation.

When inserting the batteries, be sure to do so in the proper direction, following the “q” and “w” marks in the battery compartment.

To prevent damage or leakage of battery fluid:

Do not use a new battery together with an old one.

Do not use two different types of batteries.

Do not attempt to charge dry batteries.

Do not short-circuit, disassemble, heat or dispose of batteries in flames.

If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

Remove the batteries from the remote control unit if it will not be in use for long periods.

Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.

Operating Range of the Remote Control Unit

Point the remote control unit at the remote sensor when operating it.

30° 30°

Approx. 23 feet / 7 m

NOTE

The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.