10 SURROUND
Before playing with the surround function
•Before playing with the surround function, be sure to use the test tones to adjust the playback level from the different speakers. This adjustment can be performed with the system setup (see page 25) or from the remote control unit, as described below.
•Adjusting with the remote control unit using the test tones is only possible in the “Auto” mode and only effective in the DOLBY SURROUND and HOME THX CINEMA modes. The adjusted levels for the different modes are automatically stored in the memory.
2 | 1, 3 |
| 2, 3 |
1 | Press the TEST TONE button. |
2 | Test tones are output from the different speakers. Press the |
CURSOR/PAGE button to highlight the display, then use the |
jog stick to adjust the channel level.
After completing the adjustment, press the CURSOR/PAGE
3 button again so that the display is no longer highlighted, then press the TEST TONE button to complete the operation.
•After adjusting using the test tones, make the desired settings for each surround mode to be played, then use the procedure described below to adjust the levels of the various channels.
1 | MAIN UNIT: | MODE |
Press the MODE SELECT button and select | SELECT | |
|
“CH VOL”.
The setting mode switches in the following order each time the button is pressed:
(Main unit)
REMOTE CONTROL UNIT:
Press the CH. SELECT button on the “SURROUND 2/5” page. “CH VOL” is selected.
(Remote control unit)
MAIN UNIT:
2 | Use the FUNCTION knob to select the | FUNCTION |
| ||
| speaker whose level is to be adjusted. |
|
|
| (Main unit) |
| REMOTE CONTROL UNIT: | 2, 3 |
Press the CURSOR/PAGE button on the “SURROUND 2/5” page to highlight the display, then press jog stick “ENTER”. The channel (speaker) switches as shown on the diagram below each time it is pressed.
1 | 2 | 3 |
|
| 1, 4 |
|
| 2, 4 |
(Remote control unit)
FL | C | FR |
| FADER |
|
SR 
SBR 
SBL 
SW 
SL
42
