Denon AVR-5800 After starting playback, Example Stereo, 1Adjusting the sound quality tone

3	Select the play mode.
	Example: Stereo

STEREO

	(Main unit)	(Remote control unit)
4	Start playback on the selected component.
	• For operating instructions,	refer to the component’s

Input mode display

• In the AUTO mode

INPUT MODE

AUTO PCM DTS RF

• In the PCM mode

INPUT MODE

AUTO PCM DTS RF

• In the DTS mode

INPUT MODE

AUTO PCM DTS RF

One of these lights, depending on the input signal.

ANALOG DIGITAL

DIGITAL

DIGITAL

	manual.
5	Adjust the volume.	MASTER VOLUME

• When switched to RF in the VDP RF or AUTO mode

INPUT MODE
AUTO PCM	DTS	RF	DIGITAL

• In the ANALOG mode

INPUT MODE

AUTO PCM DTS RF

ANALOG

The volume level is	(Main unit)	(Remote control unit)
displayed on the
master volume level
display.

Input signal display

• DOLBY DIGITAL

One of these lights, depending on the input signal.

The volume can be adjusted within the range of –60 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 25 or page 42, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume adjustment range is “18 dB

— (Maximum value of channel level)”.)

Input mode when playing DTS sources

•Noise will be output if DTS-compatible CDs or LDs are played in the “ANALOG” or “PCM” mode.

When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to “AUTO” or “DTS”.

NOTE:

•The digital input indicator will light (green) when playing CD- ROMs containing data other than audio signals, but no sound will be heard.

INPUTSIGNAL
LOCK DIGITAL	PRO LOGIC

• DTS

INPUTSIGNAL

LOCK DIGITAL

• PCM

INPUTSIGNAL

LOCK DIGITAL AL24

The AL24 indicator lights when the PURE DIRECT, DIRECT or STEREO mode is selected in the digital input mode.

The LOCK LED lights when digital signals are being input properly. If the LED does not light, check whether the digital input component setup (page 28) and connections are correct and whether the component’s power is turned on.

After starting playback

[1]Adjusting the sound quality (tone)

The tone control function will not work in the Direct or Home THX Cinema mode.

1	Press the MODE SELECT button and select	MODE
	TONE.	SELECT
	The mode switches as follows each time
	the MODE SELECT button is pressed:
		(Main unit)
	Only displayed when the TUNER input is
	selected.
2	Select BASS/TREBLE with the	FUNCTION
	FUNCTION knob.

(Main unit)

4 1 2 3

34