Specifications Troubleshooting Information
q
Auto Setup | q | ||
Audyssey MultEQ XT | Auto Setup | ||
Step2:Measurement | |||
Audyssey MultEQ XT | |||
Please place microphone | |||
Step2:Measurement | |||
at ear height at |
|
| |
| Now measuring 2nd | ||
2nd listening position. |
| ||
|
| listening position. | |
|
|
| |
Next |
|
|
| |
Calculate |
|
|
| |
| Front L |
| ||
Cancel |
|
| ||
| Cancel | |||
w |
| |||
|
|
| ||
Auto Setup |
| r | ||
Audyssey MultEQ XT | Auto Setup | |||
Step2:Measurement | ||||
| Audyssey MultEQ XT | |||
Please place microphone |
| |||
Step2:Measurement | ||||
at ear height at | All the measurements | |||
3rd listening position. | ||||
| were finished. | |||
Next |
| |
Calculate |
| |
Retry | Calculate | |
Cancel | ||
Retry | ||
| ||
| Cancel |
qSelect “Next 0”, then press o.
•The measurement of the 2nd position starts.
•Select “Calculate 0” with i, and press o to proceed to Step 3.
wMove the microphone to the 3rd position and press o.
•The measurement of the 3rd position starts.
•Select “Calculate 0” with i, and press o to proceed to Step 3.
ePerform repeatedly through the 6th position or more. A maximum of 8 position can be measured .
r“All the measurements were finished.” is displayed on the on- screen display, when you have completed measurements in 8th positions.
•Select “Calculate 0”, and press o to proceed to Step 3.
nTo cancel Auto Setup
Press ui to select “Cancel 0”, then press o.
After completing a measurement position, move the microphone to the next position.
Measure at least 6 positions: the main listening position and 5 other surrounding positions. Although it is allowable to measure less than 6 positions, it is recommended to measure 6 or more positions (with a maximum of 8 positions) for best results.
F Menu screen F
q
Auto Setup
Audyssey MultEQ XT
Step3:Calculation
Calculating
Please wait...
The values obtained from the measurements are automatically analyzed and the attributes for each of the speakers in the listening area are determined.
qSelect “Calculate 0” at Step 2, then press o.
• Analysis begins.
•Analysis takes several minutes to complete.
•The time required for this analysis depends on the number of speakers connected. The greater the number of speakers connected, the longer analysis will take.
NOTE
•Do not change the speaker connections or subwoofer volume, or speaker locations after making measurements. If changes are necessary, make the changes and use Audyssey MultEQ XT auto setup once again for an updated EQ solution.
•For instance, if the location or direction of a speaker is altered, the Auto Setup should be performed again to ensure the correct EQ solution for the new room configuration.
F Menu screen F
q
Auto Setup
Audyssey MultEQ XT
Step4:Check
Please check the results
of the measured item.
Speaker Config.Check
Distance Check
Channel Level Check
Crossover Freq.Check
Next
When analysis is complete, check the analysis results for the following four items.
qMake your selection using ui and press ENTER.
•Presence and size of speaker “Speaker Config. Check”
•Distance of speaker from listening position “Distance Check”
•Speaker channel level “Channel Level Check”
•Crossover Frequency “Crossover Freq. Check”
wUse ui to change which speaker is displayed. e Press RETURN.
This returns you to analysis results items, so repeat step q.
r Press i to select “Next 0”, and then press o to proceed to Step 5.
Distance values that are greater than the actual distance of a speaker may be accurate for speakers with