(o: front, p: rear)

Specifications Troubleshooting Information zone-Multi Control Remote Playback Setup Connections Started Getting

Operations

1Connect the HDMI to the AVR-989 with equipment compatible with the HDMI control function (vpage 58).

2Put the power on for all the equipment connected to the HDMI.

3Check the settings for all the equipment connected to the HDMI and make HDMI available to them.

b Please consult the operating instructions for the connected equipment to check the settings.

b Steps 1~3 do not have to be repeated once started.

b Carryout steps 2 and 3 should any of the equipment be plugged out.

4Switch the television input to the HDMI connected to the AVR-989.

5Switch the AVR-989 input to the HDMI input source and check if the picture from the player is ok.

6Put the television power on standby and check if the AVR-989 goes into standby.

If the AVR-989 does not work please check the following.

•Is the menu “Manual Setup” – “HDMI Setup” – “HDMI Control” (vpage 30) set to “ON”?

•Is the menu “Manual Setup” – “HDMI Setup” – “Power Off Control” (vpage 30) set to “ON”?

•Is the control function used for the television HDMI properly set? (Check the television operating instructions for details.)

•Should any of the operations below be performed, the interlocking function may be reset, in which case, repeat step’s 2 and 3.

•Menu “Input Setup” – “Assign” – “HDMI In” (vpage 38) setting has changed.

•There is a change to the connection between the equipment and the HDMI, or an increase in equipment.

Symbols used to indicate buttons in this manual

Button located on both the main unit

and the remote control unit BUTTON

Button only on the main unit <BUTTON>

Button only on the remote control unit [BUTTON]

<STANDARD> <DSP SIMULATION> uiop

<POWER>

CH SELECT/ENTER QUICK SELECT

[Front]

[Rear]

QUICK SELECT

 

CH SELECT/

uiop

ENTER

CH SELECT/

uiop

ENTER

Channel Level

You can adjust the channel level either according to the playback sources or to suit your taste, as described below.

1Press CH SELECT/ENTER.

Channel Volume

FL

0.0dB

SR

0.0dB

C

0.0dB

SBR

0.0dB

FR

0.0dB SBL

0.0dB

SW

0.0dB SL

0.0dB

Fader

FRONT:REAR

2Use ui or CH SELECT/ENTER to select the speaker. The speaker that can be set switches each time one of the buttons is pressed.

3Use o p to adjust the volume.

b In the case of a subwoofer, reducing the volume when it is at “–12 dB” will change the setting to “OFF” (none).

NOTE

When the input source is “iPod”, you cannot perform channel level setting.

Fader Function

This function lets you adjust (fade) the sound from all the front or rear speakers at once.

1Press CH SELECT/ENTER.

2Press ui or CH SELECT/ENTER to select “Fader”.3Use o p to adjust the volume of the speakers.

•The fader function does not affect the subwoofer.

•The fader can be adjusted until the volume of the speaker adjusted to the lowest value is –12 dB.