gQuick Select Name

Change the Quick Select name.

Up to 16 characters can be input.

[Input characters]A ~ Z a ~ z 0 ~ 9 ! # % & ’ ( ) * + , - . / : ; = “ ? @ [ \ ] (space)

Default

Reset the settings to the default values.

hTrigger Out

Select the conditions to turn on the trigger out with respect to the zone, input source, surround mode, etc. For details about the trigger out function, see page 19.

Selecting the Zone

Select the zone for which the trigger out is set.

[Selectable items] All MAIN ZONE2Setting with Respect to the Input Source

When the input source set to on is selected, the trigger out turns on.

[Selectable items]

ON : Activate trigger on this mode.

–– – : Do not activate trigger on this mode.

Setting with Respect to the Surround Mode

•When the surround mode set to on is selected, the trigger out turns on.

•Associated with respect to surround modes that are set to “ON”.

•This can be set if the “MAIN ZONE” is selected at “Selecting the Zone”.

•Associated when an input source for which “Setting with Respect to the Input Source” is set to “ON” is selected.

[Selectable items]

ON : Activate trigger on this mode.

–– – : Do not activate trigger on this mode.

Default

Reset the settings to the default values.

jRemote ID Setup

Set remote control ID.

[Selectable items]

1

 

2

 

3

 

4

When using the AVR-989 with only the included remote control unit (RC-1105), use Remote ID “1” (default).

When using a separately sold remote control unit (RC-7000CI, etc.), this function can be used. Match the ID setting of the remote control unit and the receiver.

k232C Port

Set when external controller or 2-way remote control unit is connected.

[Selectable items]

Serial Control : Set when using an external controller.

2Way Remote : Set when using a 2-way remote control unit.

NOTE

When using a 2-way remote control unit (RC-7000CI and RC-7001RCI, sold separately), set this to “2Way Remote”.

In this case, you can not use the RS-232C connector as an external controller.

lDisplay

Adjust display brightness of the receiver.

[Selectable items]

Bright : Normal display brightness.

Dim : Reduced display brightness.

Dark : Very low display brightness.

OFF : Display is off unless controls are operated.

A0Setup Lock

Protect settings from inadvertent change.

[Selectable items]

ON : Turn protection on.

OFF : Turn protection off.

•When “Setup Lock” is set to “ON”, the settings listed below can no longer be changed. Also, “SETUP LOCKED!” is displayed if you attempt to operate related settings.

⋅RESTORER

⋅Night Mode

⋅MultEQ XT

⋅Dynamic EQ

⋅Dynamic Volume

⋅Channel Level

⋅Audio Delay

•To cancel the setting, press <MENU> or [A.MENU] to re-display the “Setup Lock” screen, then change the setting to “OFF”.

Specifications Troubleshooting Information zone-Multi Control Remote Playback Setup Connections Started Getting

When setting to “OFF”, the display brightness of the menu setting in operation changes to “Dark”.

For details on how to select, set and cancel settings for each menu, see “Menu Operations” (vpage 20).

34