Setup Connections Started Getting

A5SB CH Out (for 2-channel sources)

Determine whether to use surround back speakers.

[Selectable items]

ON : The surround back channel signal is played.

OFF : The surround back channel signal is not played.

This operation can be performed directly pressing <SURROUND BACK>.

Tone

Adjust the tonal quality of the sound.

A8Tone Control

Turn tone adjustments off.

[Selectable items]

ON : Allow tone adjustment (treble, bass).

OFF : Playback without tone adjustment.

Audyssey Settings

Select MultEQ XT, Dynamic EQ and Dynamic Volume.

S1MultEQ XT

Select the type of room correction desired from the following list:

[Selectable items]

Audyssey : Optimize frequency response of all speakers.

Audyssey Byp. L/R : Optimize frequency response of speakers except front L and R speakers.

Specifications Troubleshooting Information zone-Multi Control Remote Playback

A6SUBWOOFER ATT

Attenuate subwoofer level when using EXT. IN mode.

[Selectable items]

ON : The input from the subwoofer channel is attenuated.

OFF : The input from the subwoofer channel is not attenuated. Usually use in this mode.

Set this to “ON” if the subwoofer channel level seems too high when playing audio signal.

A7Subwoofer

Turn subwoofer output on and off.

[Selectable items]

ON : The subwoofer is used.

OFF : The subwoofer is not used.

The tone cannot be adjusted when in the DIRECT mode.

NOTE

When the “Dynamic EQ” setting is “ON”, setting is not possible.

A9Bass

Adjust low frequency range (bass).

[Variable range]

–6dB ~ +6dB

 

 

S0Treble

Adjust high frequency range (treble).

[Variable range]

–6dB ~ +6dB

“Bass” and “Treble” can be set when “Tone Control” is set to “ON”.

Audyssey Flat : Optimize frequency response of all speakers to flat response.

Manual : Apply frequency response set with “Manual EQ” (vpage 31).

 

 

OFF

 

 

: Turn equalizer off.

 

 

 

 

Audyssey

 

 

Audyssey Byp. L/R

 

 

 

 

 

 

 

OFF

 

 

 

Manual

 

Audyssey Flat

 

 

 

 

 

 

Operating from the main unit or remote control unit

Press MULTEQ XT.

•When “Audyssey”, “Audyssey Byp. L/R” or “Audyssey Flat” is

selected, “” lights.

•After running Auto Setup, if the Speaker Configuration, Distance, Channel Level, and Crossover Frequency have changed without

increasing the number of speakers measured, only “” lights.

•“Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be selected after the auto setup procedure has been performed.

•After performing “Auto Setup”, the “MultEQ XT” setting automatically becomes “Audyssey”.

•If the settings of speakers for which “None” has been determined at “Auto Setup” are changed, “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” cannot be selected. Either perform Auto Setup again, or return to the setting after running Auto Setup with “Auto Setup” – “Parameter Check” – “Restore”.

•MultEQ XT and Manual EQ set to “Not Used” with “Manual Setup”

– “Audio Setup” – “EQ Preset” – “EQ Customize” (vpage 31) on the menu, cannot be selected.

•When using headphones, “MultEQ XT” is set to “OFF”.

45For details on adjusting individual parameters, see “Adjusting the parameters” (vpage 42).