Denon AVR-989 sParameter Check, Error Messages, NOTE, NOTE, ENTER, Step 5 : Store, FMenu screen F q, nTo cancel storing, [Selectable items]

Step 5 : StoreFMenu screen F q

Auto Setup
Audyssey MultEQ XT	Auto Setup
Step5:Store
	Audyssey MultEQ XT
Please select “Store”
	Step5:Store
to store measurement
	Storing
values.
	Please wait...

Store

Cancel

The auto setup measurement results are stored in the AVR-989.

qSelect “Store 0”, then press o.

•“Storing Please wait...” is displayed on the on-screen display while the results are being stored.

•When storing is complete, “Storing complete. Auto Setup is now finished.” is displayed on the on-screen display.

wSelect “Exit”, then press ENTER.

eDisconnect the setup microphone from the AVR-989.

nTo cancel storing

Press ui to select “Cancel 0”, then press o.

• All the measured auto setup data will be erased.

NOTE

Do not turn the power off while the settings are being stored.

sParameter Check

Check auto setup measurement results.

This is displayed after the auto setup procedure is completed.

[Selectable items]
Speaker Config. Check	Distance Check
Channel Level Check	Crossover Freq. Check
EQ Check

Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the auto setup procedure over again.

Error messages (examples)

Cause

Measures

Auto Setup

• Included setup microphone is not connected.

• Connect the included setup microphone to the SETUP

MIC jack on the main unit.

Audyssey

MultEQ

XT

Caution!

• Not all speakers could be detected.

• Check the speaker connections.

Microphone:None

• The

front

L speaker

was not

properly

or

Speaker

:None

detected.

Retry

Cancel

Auto Setup

• Too

much

noise in

the

room

for

accurate

• Either turn off any device generating noise or move it

measurements to be made.

away.

Audyssey

MultEQ

XT

Caution!

• Try again when the surroundings are quieter.

Ambient noise is

• Speaker or subwoofer sound is too low for

• Check the speaker installation and the direction

in

too high or

Level is too low.

accurate measurements to be made.

which the speakers are facing.

• Adjust the subwoofer’s volume.

Retry

Cancel

• Displayed speaker could not be detected.

• Check the connections of the displayed speaker.

Auto Setup

· The front R speaker were not properly

Audyssey

MultEQ

XT

detected.

Caution!

· Only one channel of the surround speakers

Front

was detected.

· Sound was output from the R channel

R :None

Retry

when only one surround back speaker was

connected.

Cancel

· The surround back, but the surround speaker

was not detected.

Auto Setup

• Displayed

speaker

connected

with the

• Check the polarities of the displayed speaker.

be

Audyssey

MultEQ

XT

polarities reversed.

• For some speakers, this error message may

Caution!

displayed even if the speaker is properly connected. If

Front

you are sure that the wiring is correct, select “Skip”.

L :Phase

Retry

Cancel

Skip

Specifications Troubleshooting Information zone-Multi Control Remote Playback Setup Connections Started Getting

The auto setup results can be set again when “Restore” is selected. Select “Retry” to measure again.

NOTE Be sure to turn the power off before checking the speaker connections.