Denon DVD-1000 manual Inserting Batteries, Using the Remote Control Unit, English

ENGLISH

6 REMOTE CONTROL UNIT

2The DVD-1000 can be controlled from a distance using the included remote control unit (RC-543).

(1) Inserting Batteries

qRemove the remote control unit’s rear cover.

wPlace two “AA” (R6P) batteries in the battery compartment in the direction indicated by the marks.

eClose the rear cover.

Cautions On Batteries

•Use “AA” (R6P) batteries in this remote control unit.

•Replace the batteries with new ones approximately once a year, though this depends on the frequency with which the remote control unit is used.

•If the remote control unit does not operate from close to the main unit, replace the batteries with new ones, even if less than a year has passed.

•The included battery is only for verifying operation. Replace it with a new battery as soon as possible.

•When inserting the batteries, be careful to do so in the proper direction, following the < and > marks in the remote control unit’s battery compartment.

•To prevent damage or battery fluid leakage:

•Do not use a new battery with an old one.

•Do not use two different types of batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Remove the batteries when not planning to use the remote control unit for a long period of time.

•If the batteries should leak, carefully wipe off the fluid from the inside of the battery compartment, then insert new batteries.

(2) Using the Remote Control Unit

Approx. 7 meters

30°

30°

•When operating the remote control unit, point it at the remote control sensor as shown on the diagram.

•The remote control unit can be used from a direct distance of approximately 7 meters. This distance will be shorter, however, if there are obstacles in the way or if the remote control unit is not pointed directly at the remote control sensor.

•The remote control unit can be operated at a horizontal angle of up to 30° with respect to the remote control sensor.

NOTES:

•It may be difficult to operate the remote control unit if the remote control sensor is exposed to direct sunlight or strong artificial light.

•Do not press buttons on the main unit and on the remote control unit at the same time. Doing so will result in malfunction.

15