Connecting Other Sources

Connecting a component connections (Better than S-Video picture quality)

 

Monitor TV

DF

COMPONENT VIDEO IN

Y

PB/CB

PR/CR

PROGRESSIVE/INTERLACED

•Set the “TV TYPE” in “VIDEO SETUP” in “SETUP” in “HELP” to comply with your TV’s video format. When the TV is NTSC formatted set to NTSC.

•When the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel is set to “PROGRESSIVE”, no video signals are output from the VIDEO OUT or S-VIDEO OUT terminals. Set the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel to “INTERLACED”, if you

want to use the VIDEO OUT or S-VIDEO OUT signals. ( page 11, 15).

ENGLISH

Connecting Other Sources

To change the speaker cable

Refer to the procedure below if you want to switch to a different speaker cable. This example describes how to mount the “+” side cable to the connector. Mount the “–“ side cable in the same way.

qInsert the included hexagonal wrench into the hole

at the side of the connector’s “+” side. (Arrow A)

 

 

 

w Turn the hexagonal wrench in the direction of

 

 

 

arrow B to loosen the cable.

 

A

 

e Pull out the old cable. Be careful not to leave any

C

 

 

broken wire parts inside the connector. (Arrow C)

 

E

r Peel off the cable’s sheath and insert the new

D

B

cable with the copper colored core wire twisted

 

 

 

tightly together into the connector. (Arrow D)

 

 

 

tTurn the hexagonal wrench in the direction of

Arrow E and tighten securely so that the cable cannot be pulled out. Be sure to connect both sides of the cable to the connectors with the proper polarities.

If the polarities are inverted, the phase may be off and the bass sound may be missing, resulting in an unnatural sound.

2To switch from interlace to progressive

• Turn off the power before changing the switch.

• Choose settings according to the TV to be connected.

• Set the PROGRESSIVE/INTERLACED switch on the ADV-S101’s rear panel to select the type of the TV.

PROGRESSIVE:

Select this when using the ADV-S101 connected to a progressive type TV.

INTERLACED:

Select this when using the ADV-S101 connected to an interlace type TV.

Connecting the antenna terminals

•An F-type FM antenna cable plug can be connected directly.

•If the FM antenna cable’s plug is not of the F-type, connect using the F-type antenna adapter (Option).

FM antenna

 

 

AM loop antenna

Direction of

Black

White

(Supplied)

 

 

 

broadcasting station

 

 

 

FM antenna

75 Ω/ohms

adapter

•For the component output only, it is possible to switch between interlace image output and progressive image output. It is not possible to specify progressive image output for the Video output connectors or S-Video output connector.

COAXIAL cable

(Option)

NOTE:

•Do not connect two FM antennas simultaneously.

• Even if an external AM antenna is used, do

 

 

 

not disconnect the AM loop antenna.

 

 

 

• Make sure AM loop antenna lead terminals

 

 

 

 

AM outdoor

do not touch metal parts of the panel.

 

Ground

antenna

 

16

ENGLISH