ENGLISH

Advanced OperationAdvanced Operation

5 FUNCTION

1

 

 

ON/STANDBY

 

 

ENTER

CURSOR

 

1

 

ON/STANDBY

TONE/SDB

 

 

 

Other functions

Adjusting the sound quality (TONE/SDB)

1 Press the TONE/SDB button.

• The tone switches as shown below each time the TONE/SDB button is pressed.

DEFEAT SDB BASS TREBLE (ON/OFF)

2 With the name of the item to be adjusted selected, press the CURSOR 0 or 1 button to adjust the level.

DEFEAT:

The signals do not pass through the SDB, bass and treble adjustment circuits, providing higher quality sound.

SDB (Supper Dynamic Bass):

Press the CURSOR 0 or 1 button to select “ON” or “OFF”. Setting SDB to “ON” makes for powerful bass sound.

BASS, TREBLE:

•To increase the bass or treble:

Press the CURSOR 1 button. (The bass or treble sound can be increased to up to +10 dB in steps of 2 dB.)

•To decrease the bass or treble:

Press the CURSOR 0 button. (The bass or treble sound can be decreased to up to –10 dB in steps of 2 dB.)

When TONE/SDB is displayed, the item can be switched pressing the CURSOR • or ª button, and TONE/SDB button. If no operation is performed within 4 seconds, the display switches back to what was previously displayed.

Auto power on function

•When the 1 button is pressed while the power is in the standby mode, the ADV-S101’s power turns on automatically, and if a disc is loaded in the S-101 the disc is played.

•The auto power on function also turns the power on when the disc holder is opened while the ADV-S101 is in the standby mode.

System functions

•This unit is equipped with a last function memory which stores the input and output setting conditions as they were immediately before the power is switched off.

This function eliminates the need to perform complicated resettings when the power is switched on.

•The unit is also equipped with a back-up memory. This function provides memory storage when the power switch is off and with the power supply cord disconnected.

Initialization of the microprocessor

When the indication of the display is not normal or when the operation of the unit does not shows the reasonable result, the initialization of the microprocessor is required by the following procedure.

1 Press the ON/STANDBY switch to set the standby mode, then unplug the set’s power supply cord from the wall power outlet.

2 Hold the following 5 button and FUNCTION button after 30 second, and plug the power supply cord into the outlet.

3 Check that the entire display is flashing with an interval of about 1 second, and release your fingers from the 2 buttons.

The microprocessor will be initialized.

•If step 3 does not work, start over from step 1.

•If the microprocessor is reset, all the buttons and the setup settings are reset to the factory default values.

41

ENGLISH