Hardware Installation
2.7.17 Chassis Open Connector
The “chassis open” function, when enabled, will alert you that the system chassis is open. To use this function, please follow the steps below.
1.Connect the “chassis sensor” cable that is attached on your system chassis to location J22 on the system board.
2.Install the “Hardware Doctor” utility contained in the provided CD. By default, the “chassis open” function is disabled. When enabled, a warning message will appear when the chassis is open. The utility may also be configured so that a beeping alarm will sound when the chassis is open. Refer to “Hardware Doctor Utility” in chapter 4 for instructions on installing the utility.
2
Pin | Function |
1Ground
2Chassis signal
3N. C.
4 +5V
35
