How to operate the tuner

Changing the reception

Changing the radio band

sensitivity for automatic

location

scanning

 

 

 

The equipment lets you select the reception sensitivity to be used for automatic scanning of stations. The two sensitivity modes available for this equipment are LOC mode and DX mode.

 

During automatic scanning, the

 

reception sensitivity switches

 

automatically to one of two levels.

 

Initially the reception sensitivity is

LOC Mode

set to the low level so that only

stations with strong signals are

 

received. If no stations could be

 

received, the reception sensitivity is

 

increased so that stations with

 

weaker signals can also be

 

received.

 

 

 

Because the reception sensitivity for

 

automatic scanning is set to the high

DX Mode

level from the start, even stations

with weaker signals can be received.

 

 

(Signal crossover may result in

 

some stations being hard to hear.)

 

 

ATTENTION

When an optional HD Radio tuner is connected, reception sensitivity is set to the LOC Mode. The DX Mode is unavailable. (U.S.A. only)

Check that the equipment is in

1 standby mode.

Press and hold the button [1], then

2 the [FM AM] button, and hold both for more than three seconds.

The mode switches between LOC mode and DX mode each time the buttons are pressed.

The location for the radio bands used between the North American region and the Asia/ Australia/Latin region can be switched. The default setting is USA (North America).

ATTENTION

When an optional HD Radio tuner is connected, radio band location is set to USA. Other radio band locations are unavailable. (U.S.A. only)

Check that the equipment is in

1 standby mode.

Press and hold the button [3], then

2 the [FM AM] button, and hold both for more than three seconds.

The radio band switches in the order shown below each time the buttons are pressed.

USA ASIA AUS LATIN

USA www

After this, the broadcast stations will be searched for automatically and stored in the buttons [1] to [6].

V

25

Page 25
Image 25
Eclipse - Fujitsu Ten CD4000 manual Changing the reception, Sensitivity for automatic, Scanning, LOC Mode, DX Mode