Eclipse - Fujitsu Ten CD4000 manual How to use the remote control, Cleaning the remote control

Operation

How to use the remote control

Precautions in use of the remote control

•Be careful when handling the control, especially because it is small and light. Dropping or striking it hard may damage it, wear out the battery or cause a malfunction.

•Keep the remote control free of moisture, dust and water. Do not subject it to shock.

•Do not place the remote control where it will get hot, such as on the dashboard or near a heater vent. Allowing the remote control to overheat may warp its case or cause other problems.

•Do not operate the remote control while driving because doing so could cause an accident.

•When using the remote control, point it toward at the remote control light receptor.

•The light receptor may not operate correctly if it is exposed to bright light such as direct sunlight.

•Be sure to press the [PWR] button on the main unit for more than two seconds to shut it down before leaving the car, or the car battery may be run down. When the main unit is shut down, the remote control will not work.

•Remove the batteries from the remote control whenever it is not to be used for a long time.

Cleaning the remote control

•Use a dry cloth to keep the remote control clean. If the remote control gets extremely dirty, clean it with a cloth moistened with diluted liquid detergent. Do not use alcohol or thinner; these compounds may damage the finish.

•In no event should benzine or thinner be used. These substances will damage the case or finish.

Remote control

17

28

39

4? 5

6

A

No. Button Name/Function

[PWR] button

Turns equipment power ON/

OFF.

[TU] button

Switches to tuner mode.

[BAND] button

Switches to radio bands and

DISC mode.

[ ] button Decreases the volume.

[MUTE] button

Activates and deactivates mute.

26