Eclipse - Fujitsu Ten CD4000 manual Making changes with Sound Adjustment Mode

How to operate the Sound Adjustment Mode

Making changes with Sound Adjustment Mode

1 Press the [SOUND] button more than one second.

Enters sound adjustment mode.

2 Turn the [SEL] button to select a setting item.

When the button is turned, the setting item changes in the following order.

Press the [SEL] button to select the setting item. After selecting the setting item, follow the procedures in the list below.

Crossover adjustment (X-Over F/R)

Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off frequencies: PASS, 80Hz and 100Hz.

1	Turn the [SEL] button to select the cut-off frequency.	PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
		…
2	Press the [SEL] button.

ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.

Crossover adjustment (X-Over NF)

Adjusts woofer (non-fader output) LPF (Low Pass filter). The system allows you to select from several cut off frequencies: PASS, 80Hz and 100Hz.

1	Turn the [SEL] button to select the cut-off frequency.	PASS ➔ 80 (Hz) ➔ 100 (Hz) ➔ PASS
		…
2	Press the [SEL] button.

ATTENTION: Slope is fixed at 18dB/oct. Adjustments cannot be made.

Non-Fader phase selection (Non-F Phase)

The merging of sound between the front and rear speakers and the woofer can be improved by selecting the phase. Switch to a phase which lets the speakers combine without any disharmony.

1	Turn the [SEL] button to select the NORMAL or REVERSE.	NORMAL: Normal phase
		REVERSE: Reverse phase
2	Press the [SEL] button.

3 Press the [RTN] button.

At this time, other adjustments can also be made in sound adjustment mode.

4 Press the [SOUND] or [RTN] button to exit sound adjustment mode.

X

41