Eclipse - Fujitsu Ten CD4000 manual Manually setting stations into memory, Preset station scan

Operation

Entering stations into memory automatically

(The automatic preset mode: ASM)

Press the [SEL] button for more

1 than two seconds until a beep is heard.

The automatic preset mode starts.

The [ASM ON] indicator on the screen flashes, and stations are automatically entered in memory under the buttons [1] to [6].

These buttons are called preset buttons.

ATTENTION

•Pressing the preset buttons ([1] to [6]) allows you to make one-touch station selections. The frequency of the selected station is indicated on the display.

•When a new station is set in memory, the station previously set in memory will be deleted.

•If there are fewer than six receivable stations, the stations set in the remaining buttons will be retained.

Manually setting stations into memory

This section covers the setting of stations in memory under the numbered buttons.

Turn the [SEL] button to the right

1 or left to tune to the station to be entered in memory.

Select any button, from [1] to [6],

2 and press it for more than two seconds.

The tuned station is now memorized and set in the selected button. Repeat the procedure to set additional manually tuned stations in memory, in turn, for the buttons [1] to

[6].These buttons are called the preset buttons.

Preset station scan

This function enables reception of all the stations in the preset buttons for five seconds each.

Press the [SEL] button for less

1 than two seconds.

[P SCAN] will appear on the display, and stations stored under the preset buttons [1] to [6] will be played for five seconds each.

To stop the preset scan mode at a

2 desired station, press the [SEL] button again.

The receiver will stay tuned to the desired station.

24