Eclipse - Fujitsu Ten CD4000 How to operate the Audio Control, Switching audio control modes

Various Settings

How to operate the AUDIO CONTROL

Switching audio control modes

Various audio control modes may be fine-tuned using this procedure.

Press the [AUDIO CONTROL] button for less than one second to select the item

1 to be adjusted.

Modes will switch in the order shown below each time the button is pressed. VOL ➔ BASS ➔ MID ➔ TREB ➔ BAL ➔ FAD ➔ NON-F*1➔ SVC*2 ➔ LOUD

➔VOL www

*1: NON-F (non-fader) Output is not affected by the settings of the BASS, MID, TREBLE, loudness function or equalizer.

*2: Setting cannot be made in FM mode.

ATTENTION

Press the [MUTE] button for less than one second to cut the volume or restore it instantly.

WARNING

Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a safe location.

Mode	Function	[AUDIO CONTROL] button
		Turn to the Left	Turn to the Right
VOL (VOLUME)	Adjusts volume.	Decreases the	Increases the volume.
		volume.
	Adjusts bass level. Bass mode can be		Emphasizes low
BASS	adjusted for each source	Softens low sounds.
			sounds.
	(CDP/CDC, FM ,AM).
	Adjusts middle level. Mid mode can be	Softens medium	Emphasizes medium
MID (MIDDLE)	adjusted for each source
		sounds.	sounds.
	(CDP/CDC, FM , AM).
	Adjusts treble level. Treble mode can be		Emphasizes high
TREB (TREBLE)	adjusted for each source	Softens high sounds.
	(CDP/CDC, FM , AM).		sounds.
BAL (BALANCE)	Adjusts left/right speaker balance.	Emphasizes left	Emphasizes right
		speakers.	speakers.
FAD (FADER)	Adjusts front/rear speaker balance.	Emphasizes rear	Emphasizes front
		speakers.	speakers.
NON-F (NON-FADER)	Adjusts non-fader level (for connected	Decreases level.	Increases level.
	sub-woofers, etc.).

36