Eclipse - Fujitsu Ten CD5000 manual Canceling the security function using a Memory Stick

ESN security operating procedure

3	A security code is entered by
	pressing the buttons [1] to [4].
	Enter a four-digit security code using
	digits 0 to 9, A to F. The number
	(shown on the display) changes in
	ascending order between 0 and 9, A
	and F each time the button is pressed.
	Each button number (1 to 4)
	corresponds to each digit (first to
	fourth) of the security code.

Press the [FUNC] button for longer

4 than one second.

If a security code is entered and the main unit verifies that it is correct, [CANCEL] will appear on the display and the security function will be canceled.

ATTENTION

If the security code that is entered does not match the code that is recorded by the main unit, [ERR] will appear on the display for two seconds and operation will continue as normal without the security function being canceled.

Canceling the security function using a Memory Stick

ATTENTION

If a Memory Stick has already been inserted, a [MS EJECT] message appears. In this case, eject the Memory Stick and insert again. (Refer to "Ejecting the Memory Stick" on page 27 for details on ejection of the Memory Stick.)

Insert the Memory Stick and close

4 the front panel.

The recorded data will be read from the Memory Stick.

If the contents recorded in the

5 Memory Stick match the information recorded by the main unit, [CANCEL] will appear on the display.

The security function will be canceled.

ATTENTION

•If a reading error occurs or if an incorrect Memory Stick is inserted, [ERR] will appear on the display for two seconds, and then the display will change to [EJECT]. If this happens, eject the Memory Stick and try again.

•Security setting cannot be canceled by this procedure if the Memory Stick containing the security code is formatted.

VIII

1	Check that the main unit is in
	standby.
		6	Eject the Memory Stick.
	Press and hold the button [1], then
2
	the [FUNC] button, and hold both		Refer to "Ejecting the Memory Stick"
	for more than one second.		on page 27.
	A [SEC] message appears, then in two
	seconds it will change to [- - - -]
	(Security code input display).
3	Press the [DISC MS] button.
	A [MS] message will appear.

39