42
Various Settings
How to operate the ACC
security
ACC security involves using Memory Stick
security to record a security code, and then when
the ignition switch is turned to OFF and back to
ACC, the operation of all the buttons is disabled.
The ACC security function will be
activated. Press the [FUNC] button
and the button [5] simultaneously for
two seconds or more again to cancel
the ACC security function.
ATTENTION
• If the vehicle's battery is disconnected at
times such as during servicing, ACC
security will be canceled.
• When ignition switch is turned OFF and
back to ACC, the operation of all the
buttons is disabled. If this happen, resume
normal operation. (Refer to "How to resume
normal operation (ESN security lock out)"
on page 40.)
How to turn the security
indicator on/off
Once ESN security is activated, the indicator
flashes whenever the vehicle's ignition switch is
turned off, warning potential thieves that the main
unit is protected. However, if you do not want this
visible deterrent, it may be turned off.
[IND. FLASH] means the security
indicator will flash when the vehicle's
ignition switch is off, and [IND.-----]
means it will not. Repeat the above
steps to reactivate the flash mode.
How to read the Electronic
Serial Number
[ESN] appears on the display, followed
by an eight-digit number; this number
is your electronic serial number (ESN).
You may use this number to identify
your Eclipse CD5000 in the event of
theft recovery.
1Check that the main unit is in
standby.
2Once a security code has been
recorded, press the [FUNC] button
and the button [5] simultaneously
for more than two seconds.
1With the main unit in standby,
press the [FUNC] button, then the
button [2] and hold both for more
than one second.
2[IND. FLASH] or [IND.-----] appears
on the display.
1Check that the main unit is in
standby.
2Press and hold the [FUNC] button,
then the button [4], and hold both
for more than one second.