Eclipse - Fujitsu Ten CD5000 manual Press the Sound or RTN button to exit sound adjustment mode

Various Settings

Non-Fader phase selection (Non-F Phase)

The merging of sound between the front and rear speakers and the woofer can be improved by selecting the phase. Switch to a phase which lets the speakers combine without any disharmony.

1	Turn the [SEL] button.	NORMAL: Normal phase
		REVERSE: Reverse phase
	Press the [SEL] button.
2

Crossover adjustment (X-Over)

The frequencies for the front and rear speaker high-pass filter (HPF) and woofer low-pass filter (LPF) can be set within a range of 63 to 200 Hz. (This is the same as the HPF and LPF cutoff frequencies.)

1 Turn the [SEL] button to select the cut-off frequency.

2 Press the [SEL] button.

3 Press the buttons to set the slope.

63Hz ➔➔ 80Hz ➔➔ 100Hz ➔➔ 125Hz ➔➔ 160Hz ➔➔ 200Hz

[ ] : Increases level.

[ ] : Decreases level.

ATTENTION: If no woofer has been connected, set the slope adjustment to "PASS". (If slope is set to a setting other than PASS, the low frequency range will not be output from the speakers.)

Multi-harmonizer settings (Harmonizer)

This function uses harmonic synthesis to restore the high-frequency component that is lost as a result of the compression process so that better sound can be obtained during MP3 /WMA or Memory Stick (ATRAC3) playback.

1	Turn the [SEL] button to	Hi : High effectiveness
		Low : Low effectiveness
	select the setting item.
	Press the [SEL] button.
2

Non-Fader Output

…OFF ➔➔ ➔➔ OFF …

Hi

➔

➔

Low

Non-Fader Output can be stereo or mono. Select the method that matches the output method for the sub- woofer system that is connected to the main unit.

1 Turn the [SEL] button to select Stereo or Monaural.

2 Press the [SEL] button.

3 Press the [RTN] button.

At this time, other adjustments can also be made in normal mode.

4 Press the [SOUND] or [RTN] button to exit sound adjustment mode.

60