Setting and Adjusting the, Setting the Security

Setting and Adjusting the

Projector (Settings & Adjustments)

Example: “Picture” screen display for INPUT 1

On these screens, you can make projector settings or adjustments.You can set or adjust the following items :

•Picture Mode

•CLR Temp

•Bright Boost

•Progressive

•C.M.S. Adjustment

•DNR

•Signal Type

•Auto Sync

•Auto Sync Disp

•Audio Out

•Internal Speaker [OFF][ON]

•Resize

•OSD Display

•Video System (INPUT 4/5)

•Background

•Startup Image

•Eco Mode [OFF][ON]

•Auto Search [OFF][ON]

•Auto Power Off [OFF][ON]

•Lamp Mode

•Projection Mode

•Keylock Level

•Set Inputs

•RS-232C Speed

•Monitor Out (Standby)

•OSD Language

•Video Wall (See page 41.)

•Stack Setting (See page 38.)

Note

•If you click the “Refresh” button before the screen is displayed completely, an error mes- sage (“Server Busy Error”) will be displayed. Wait for a moment and then operate again.

•You cannot operate this page while the pro- jector is warming up.

•While the projector is in standby mode, you can only control “Power ON”.

•For details about each item, refer to the owner’s manual of the projector.

Controlling the Projector via LAN

Setting the Security

(Network – Security)

On this screen, you can make settings relat- ing to security.

	Items	Description
User Name		Setting of user name for
		security protection.

Password		Setting of password for
		security protection.

Accept IP		It is possible to set up to three
Address		IP addresses allowing connec-
		tion to the projector.

	All IP	No limits are set to IP addresses
	Addresses	connecting to the projector.

	From only	For security improvement, only an
	specific IP	IP address set by “Address 1-3”
	addresses	can be connected to the projector.

After clicking the “Apply” button, the set val- ues appear. Confirm that the values are set properly, and then click the “Confirm” button.