Eiki/Elf EIP-4500 Setting up the Projector Network Environment, Click the “Apply” button

Setting up the Projector Network Environment

4 The TCP/IP setting screen ap- pears, ready for network settings for the projector.

Items	Setting example / Remarks
IP Address	Factory default setting: 192.168.150.2
	Enter an IP address appropriate
	for the network.
Subnet	Factory default setting: 255.255.255.0
Mask	Set the subnet mask to the same
	as that of the computer and
	equipment on the network.
Default	Factory default setting: 0.0.0.0
Gateway	* When not in use, set to “0.0.0.0”.
DNS	Factory default setting: 0.0.0.0
Server	* When not in use, set to “0.0.0.0”.

Note

•Confirm the existing network’s segment (IP address group) to avoid setting an IP ad- dress that duplicates the IP addresses of other network equipment or computers. If “192.168.150.2” is not used in the network having an IP address of “192.168.150.XXX”, you don’t have to change the projector IP address.

•For details about each setting, consult your network administrator.

5 Click the “Apply” button.

6

The set values appear. Confirm that the values are set properly, and then click the “Confirm” but- ton.

•After setting items, wait for 10 seconds and then re-access.

This completes the network settings.

Change the IP address of the setting computer back to its original address, and then con- nect the computer and the projector to the network.

22