Connection of LAN cable

[2] Connection of LAN cable

To connect to the network, it is required to use the UTP (Unshielded Twisted Pair) straight cable with RJ-45 plug. There are two different types of cables depending on whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub (10Base-T or 100Base-TX) to distribute the network cable if required.

1Turn the Mains switch off.

2Wind the UTP straight cable once around the ferrite core (supplied) as the illustrated below.

LAMP

READY WARNING TEMP. LAMP REPLACE

Ferrite Core

Mains Switch

 

 

3Connect the UTP straight cable to the LAN port on the network board.

4Connect the UTP straight cable to the hub.

Hub

(10BaseT, 100Base-TX)

UTP straight cable

Projector

ENGLISH

Use the UTP cross cable when you connect the computer and projector directly not using the hub.

When you connect the projector into the 10Base-T network, use cable with category 3 or 5. When you connect the projector into the 100Base-TX network, use cable with category 5.

The length of cable between hub and projector should be less than 100m.

Network Board

OWNER’S MANUAL

13

Page 13
Image 13
Eiki MD13NET owner manual Connection of LAN cable