Installation

[1] Mounting

1Turn the Mains switch off.

LAMP

READY

WARNING

TEMP.

LAMP

REPLACE

Mains Switch

2 Remove 2 screws on a board from any of the slots 1 to 4*, and then pull the board out from the projector.

*The number of the slots may differ from the actual depend- ing on type of the projector.

3 Put the Board into the board slot along the guide. Mount the board connector into the socket in the slot firmly.

Guide

4 Secure the board with two screws (supplied).

* Mounting example of the 4 slots model.

!Caution

Mains switch must be turned off when mounting or removing this product otherwise it may damage the product.

Do not install multiple network boards into a projector otherwise it may damage the product.

Do not connect the AC cord until after connecting the LAN cable and computer.

12

Page 12
Image 12
Eiki MD13NET owner manual Mounting, Secure the board with two screws supplied