Use of telnet
3 The following window will appear. Type as follows and then press the Connect button.
Host name | : 192.168.0.2 |
(type projector IP address) | |
Port | : telnet or 23 |
Terminal type : vt100
4 When communication is established, the word “PASSWORD:” appears on the window. Type the login password* for the projector and then press the “Enter” key on the keyboard. If you do not register the login password, just press the “Enter” key.
When the word “Hello” is replied, login has been successful.
For example, entering password [1234]
5 Type the commands from the key board to control the external equipment and then enter the “Enter” key for termination. For example, type “C00” and enter the “Enter” key. The projector will be turned on. The “C00” is a command to turn the projector on.
To disconnect the communication, select the Disconnect sub menu from the Connect pulldown menu. To quit the telnet application, select the Quit telnet sub menu from the Connect menu.
ENGLISH
*The password is a login password decided on page 17 or 30. If the authentication of the entered password is failed 4 times continuously, the communication will be disconnected automatically. Please try again for the connection.
Network Board
OWNER’S MANUAL
67
