Controlling the Multi-Projectors

Exclude/Add/Delete a projec-

tor

To change the mode of the registered pro- jectors, Select a mode with the pull-down menu button under the IP address of the target projector and then press the Set button.

Status

Mode

Operation

OFF

: Exclude from the multi-control

ON

: Add to the multi-control

Delete

: Delete from the multi-control

If some of the registered projectors are deactivated by some means (such as dis- connecting the power source, disconnect- ing the LAN cable, disconnecting from the network), control changes will continue to be effective for the projectors that are still activated. At the same time, the deactivat- ed projectors are excluded from the multi- control. The status of the registered pro- jectors are indicated under the projector name. See the table below for status indi- cations.

Status

Description

(blank)

The projector is connected to the network correctly

No connection

The projector may not be connected to the network. Please check the connection

 

and network configuration of this projector.

Password error

The login password is incorrect. The password for the multi-controlled projectors

 

must be the same. Change password of this projector to the common password.

If the multi-controlled projector is in the standby mode, any change is not effective except timer setting.

It is recommended that a specified projector should be chosen for setting when you use this multi-control function. The control for the multi-controlled projectors will become too compli- cated operation if this function is used for each projector.

If the registered projector is not connected to the network, it will take some time to complete the multi-control operation because the network board is waiting for the response from each registered projector.

58

Page 58
Image 58
Eiki MD13NET owner manual Exclude/Add/Delete a projec Tor, Status