Use of Serial Port
Control the projector with Telnet
This product allows you to control the projector by using the Telnet application. Normally, it is used to control the external equipment connected to the serial port and also control the projector itself by specifying the telnet port no.10000.
Specify port no. 10000 as the right on the serial port setting page. This function does not depend on other setting items.
In the setting of the computer, specify the port no. 10000 at the procedure 3 on the previous setting example page as the below.
Host name | : 192.168.0.2 |
| (type a projector IP address) |
Port | : 10000 |
Terminal type | : vt100 |
After established the communication, type the password and the command for controlling the projector and then enter the “Enter” key.
The right table shows the typical command lists for controlling our projectors and please consult your local dealer for further information of anoth- er commands.
Command list table
Command | Function |
|
|
C00 | Turn the projector on |
C01 | Turn the projector off |
C05 | Selects SLOT1 |
C06 | Selects SLOT2 |
C07 | Selects SLOT3 |
C08 | Selects SLOT4* |
C09 | Volume up |
C0A | Volume down |
C0B | Mute on |
C0C | Mute off |
C0D | Video mute on |
C0E | Video mute off |
C1C | Menu display on |
C1D | menu display off |
|
|
* Only effective for the 4 slots model.
68
